Gear Manufacturing

Industrial Gear Manufacturing

Bilgi Dişli reviews gear manufacturing enquiries using drawings, samples and operating information. We consider gear geometry, material and mounting features together so the production scope reflects how the transmission will actually work.

Gear selection
Based on shaft layout and duty
Technical review
Drawings, samples and mating parts
Production scope
Individual gears or mating sets
MANUFACTURING EXPERTISE

Choosing a gear type for the motion required

A gear cannot be selected by outside diameter or tooth count alone. Shaft arrangement, transmitted torque, speed, operating time and lubrication must be considered together. For parallel shafts, spur gears are a common option; a helical design may suit applications where more gradual tooth engagement is useful. The housing, bearings and existing mating gear also constrain the choice. Operating information is therefore an essential part of a meaningful manufacturing enquiry.
Starting points for selecting a gear arrangement
Motion arrangementSolution to considerAssociated consideration
Parallel shaftsSpur or helical gearsMating geometry and bearing arrangement
Intersecting shaftsBevel gearsShaft angle and mounting position
Rotation to linear motionRack and pinionPitch, travel and guidance
Crossed shafts and a high reduction ratioWorm gear setHeat, lubrication and efficiency

Material, process sequence and mounting fit

Material and heat treatment depend on tooth contact loading, tooth root stress and the required core strength. Surface hardness alone is not a complete acceptance criterion. Machinability, distortion after heat treatment and allowance for subsequent finishing all belong in the production plan. Bores, keyways, hubs and reference faces matter as much as tooth geometry: the relationship between these features determines how the component locates within the assembly.

Where a transmission changes direction, the mounting position of a bevel gear pair needs particular attention. For a replacement component, the condition of the mating gear, bearing clearances and housing wear should also be reviewed. Defining a new part only from a worn sample can reproduce the effects of an existing operating problem.
Generating tooth profiles with a hob

The helical cutting tool and gear blank rotate together. Chips leaving the cutting region illustrate the principle of generating a tooth profile.

What should the manufacturing drawing specify?

  • Gear type, module or pitch, tooth count, pressure angle and any profile shift.
  • Type-specific geometry, such as helix hand and angle or the shaft angle of a bevel pair.
  • Face width, bore or shaft dimensions, keyway and assembly reference surfaces.
  • Material, required heat treatment, hardness zones and finishing requirements.
  • Functional tolerances, quality requirements, mating part and assembly clearance information.
  • Drawing revision, quantity, operating environment and any required inspection documentation.

Preparing a gear manufacturing enquiry

Include a legible drawing, a three-dimensional model if available and the required quantity. If no drawing exists, provide photographs of the sample together with operating speed, loading and failure history. State whether the requirement covers one gear or a mating set. When you send Bilgi Dişli your technical enquiry, include expectations for material supply, heat treatment and inspection so the quotation can be assessed against a clearly defined scope.

Frequently Asked Questions

Can a gear be manufactured from a sample?

A sample is a useful starting point for understanding geometry. Worn teeth, modified bores or damaged reference features may no longer represent the original design. It should be reviewed alongside the mating gear, mounting dimensions and operating information before the production definition is established.

Is replacing one gear enough?

Wear on the mating gear affects contact and backlash. The decision to replace only one component depends on the condition of the pair, the cause of damage and assembly conditions. In some applications, the mating components are better considered together.

Can all gears use the same material and hardness?

No. Continuous duty, shock loading, lubrication, dimensions and component construction change the material requirements. Surface hardness and core strength need an application-specific balance, with material and heat treatment defined together on the drawing.

CONNECTED MANUFACTURING

The next step
for your component.

Geometry, connection details and operating conditions shape the next process. Explore the services that complement your component.